Shredder manufacturers teach you how to use large double-shaft shredders correctly

The large double-shaft shredder is mainly composed of two shredding blade sets, a shredding box, a box bracket, a feeding system, and a power system. Therefore, the equipment requires two reducers and motors to drive, and the shredding power is strong , high operating efficiency. Let’s teach you how to use a large double-shaft shredder correctly:

   1. First of all, turn on the machine and preheat it before working, observe whether the equipment is operating normally and whether there are any abnormal sounds, and then start feeding after everything is normal;

   2. When feeding, the material must be fed evenly, not too fast or too slow, too much or too little, and when feeding, it must be small first and then large, so as not to exceed the load that the motor can bear right after starting.

   3. If any noise or vibration is found, stop the machine immediately for inspection, and continue working after the fault is eliminated.

   4. When shutting down, you can idle it for two minutes and wait until all the materials are discharged before shutting down. This operation can not only improve the production efficiency of the large double-shaft shredder, but also effectively increase the service life of the equipment.

What are the correct operating steps for a large shredder?

   The large shredder is a new type of shredder that uses unique abrasion technology in the cutting and shredding process and can shred large amounts of paper, plastic, fiber and other materials. The advantage of a large shredder is that it can greatly improve work efficiency and can complete a large amount of shredding work faster than a traditional shredder.

   The following are the correct operating steps for large shredders:

   1. Turn on the power of the shredder, press the switch, and observe the operation of the machine;

   2. Put the materials to be shredded into the shredder. The materials must be flat and neat;

   3. Press the shredding button to start shredding;

   4. During the shredding process, the operation of the machine should be checked frequently. If any abnormalities are found, they should be dealt with in time;

   5. After the shredding is completed, take out the shredded materials and observe whether the shredding effect meets the requirements;

   6. After the shredding is completed, clean the remaining materials in the equipment, clean the large shredder, and keep the shredder clean and hygienic.